Universal 4-lamp CCFL Inverter Board for LCD panels

One piece brand new universal CCFL inverter high voltage board for 2 lamp LCD repair.  Includes 4-wire harness as shown.   Ideal for use with 19” or smaller displays or lamps that measure around 400mm or less in length.  Inverter will not function properly unless all 4 lamps are connected.  

Size: 3.5cm x 13.3cm

Input Working Voltage: 10-13V, 12V typical

Output Current:  7-9mA
Output Voltage:  800 Vrms
Output Ignition/Starting Voltage:  1720 Vrms typical; 1300 Vrms Min

Inverter 6 Pin Connector Assignment:
1 – VIN: power supply (10-13V) – RED WIRE
2 – VIN: power supply (10-13V)
3 – ENA (enable, ON = 1.5V-5.0V; OFF = 0-0.5V) switch signal – YELLOW WIRE
4 – ADJ (dimming function / brightness control; 0V = Max Brightness, 5V = Min Brightness) - YELLOW WIRE
5 – GND (Ground wire)
6 – GND (Ground wire) – BLACK WIRE
 
Wire Harness:
Red Wire= Input (pin #1)
Yellow Wire = Switch on/off (pin #3)
Yellow Wire = Dimming / brightness (pin #4)
Black Wire = Ground (pin #6)

2-pin output connectors:
Pin 1 = High Voltage (800V)
Pin 2 = Low Voltage (0-18V)